GPSC RTO Exam Most IMP MCQ Test-03

1.Which one of the following compressors will be used in vapour compression refrigerator for plants up to 100 tonnes capacity?

A) Reciprocating compressor
B) Rotary compressor
C) Centrifugal compressor
D) Double-acting compressor

... The answer is A)
Reciprocating compressor

2. Consider the following statements: An expansion device in a refrigeration system 

1. reduces the pressure from the condenser to the evaporator 

2. regulates the flow of the refrigerant to the evaporator depending on the load 

3. is essentially a restriction offering resistance to flow 

Which of the above statements are correct?

A) 1 and 2 only
B) 1 and 3 only
C) 2 and 3 only
D) 1, 2 and 3

... The answer is D)
1, 2 and 3

3.Which one of the following systems is consisting of processing stations, material handling and storage, computer control system and human labour?

A)Portable manufacturing system
B) Focused integrated system
C) Flexible manufacturing system
D) Automated integrated system

... The answer is C)
Flexible manufacturing system

4. In an Electrolux refrigerator, a thermo-siphon bubble pump is used to lift the

A) weak aqua solution from the generator to the separator
B) weak aqua solution from the separator to the absorber
C) strong aqua solution from the generator to the separator
D) strong aqua solution from the generator to the evaporator

... The answer is A)
weak aqua solution from the generator to the separator

5. If the relative humidity of atmospheric air is 100%, then the wet-bulb temperature will be

A)more than dry-bulb temperature
B) equal to dew-point temperature
C) equal to dry-bulb temperature
D) less than dry-bulb temperature

... The answer is B)
equal to dew-point temperature

6. The hydraulic efficiency of a turbine is the ratio of

A) mechanical energy in the output shaft at coupling and hydrodynamic energy available from the fluid
B) mechanical energy supplied by the rotor and hydrodynamic energy available from the fluid
C) useful hydrodynamic energy in the fluid at final discharge and mechanical energy supplied to the rotor
D) useful hydrodynamic energy in the fluid at final discharge and mechanical energy supplied to the shaft and coupling

... The answer is B)
mechanical energy supplied by the rotor and hydrodynamic energy available from the fluid

7. The efficiency of superheat Rankine cycle is higher than that of simple Rankine cycle because

A) the enthalpy of main steam is higher for superheat cycle
B)the mean temperature of heat addition is higher for superheat cycle
C) the temperature of steam in the condenser is high
D) the quality of steam in the condenser is low

... The answer is B)
the mean temperature of heat addition is higher for superheat cycle

8. In steam power cycle, the process of removing non-condensable gases is called

A) scavenging process
B) deaeration process
C) exhaust process
D) condensation process

... The answer is B)
deaeration process

9. A turbine in which steam expands both in nozzle as well as in blades is called as

A) impulse reaction turbine
B)reciprocating steam turbine
C) gas turbine
D) Curtis turbine

... The answer is A)
impulse reaction turbine

10. Punishment for the offence committed by a juvenile under motor vehicle amendment act 2019

A) Five Thousand & two Years imprisonment
B) Ten Thousand & & two Years imprisonment
C) Twenty Five Thousand & & Three Years imprisonment
D) Twenty five Thousand

... The answer is C)
Twenty Five Thousand & & Three Years imprisonment